10 Easy Steps: How To Make A Gravity Bong With A Socket

Create the Chamber

1. Put together the bottle: Reduce the underside off the bottle, leaving a gap about 2-3 inches in diameter. This would be the chamber.

2. Make the socket gap: On the facet of the bottle, about 2/3 of the best way up from the underside, use a drill or sharp object to make a gap that’s barely bigger than the diameter of the socket.

3. Join the socket: Insert the socket into the opening and seal it firmly with duct tape or scorching glue. Ensure the seal is hermetic to make sure a correct vacuum.

Seal the Bowl

Correctly sealing the bowl is essential to creating an efficient gravity bong. Observe these steps to make sure a leak-proof seal:

Collect Essential Supplies

• Positive-grained grinding herb
• Small bowl piece
• Plastic socket
• Gaffer’s tape

Put together the Socket

• Create small holes within the backside of the socket utilizing a needle or sharp object.
• Insert the bowl piece into the socket, making certain it matches snugly.
• Wrap gaffer’s tape across the base of the bowl and socket a number of occasions to create an hermetic seal.

Load the Herb

• Grind the herb finely utilizing a grinder or scissors.
• Pack the bottom herb into the bowl piece, urgent it down firmly.

Safe the Seal

• Place the socket-bowl meeting over the top of the bottle or bucket.
• Press down firmly to create a good seal between the socket and the bottle.
• Examine for any leaks by barely lifting the socket. If there are leaks, tighten the seal with extra gaffer’s tape.

Extra Ideas

• Use a clear socket to stop any odors or chemical compounds from contaminating the smoke.
• Experiment with completely different bowl sizes and shapes to seek out what works finest for you.
• Exchange the gaffer’s tape often to make sure a correct seal.

Assemble the Lid

Now let’s assemble the lid. This can kind the “head” of your gravity bong and can maintain the bowl in place.

1. Reduce a gap within the lid. Use a pointy knife to chop a gap within the lid that’s barely bigger than the bowl. The outlet must be centered on the lid.
2. Place the bowl within the gap. The bowl ought to match snugly into the opening, in order that there isn’t any air leaks. If the opening is just too huge, you need to use some tape or putty to seal it across the bowl.
3. Insert the stem into the lid. The stem is the a part of the gravity bong that connects the lid to the bottle. It must be lengthy sufficient to achieve from the opening within the lid to simply under the floor of the water within the bottle.
4. Seal the lid onto the bottle. Use a number of items of tape or some putty to seal the lid onto the bottle. Guarantee that the seal is hermetic, in order that no air can leak out of the bottle.

Ideas for Assembling the Lid

Listed here are a number of suggestions for assembling the lid of your gravity bong:

Inhale the Smoke

Now that your gravity bong is assembled, it is time to inhale the smoke. Here is how:

1. Inhale by means of the mouthpiece, pulling the bottle up slowly.
2. Because the bottle rises, the smoke will fill the chamber.
3. Proceed inhaling till the bottle is totally the other way up.
4. Maintain the bottle the other way up for a second, permitting the smoke to chill barely.
5. Slowly exhale the smoke.
6. Repeat steps 1-5 to take one other hit.

Ideas for Inhaling the Smoke:

Listed here are a number of suggestions that can assist you inhale the smoke from a gravity bong easily and successfully:

1. Inhale slowly and steadily.
2. Do not attempt to inhale an excessive amount of smoke directly.
3. Maintain the smoke in your lungs for a number of seconds earlier than exhaling.
4. If you happen to begin to really feel lightheaded, cease inhaling and take a break.
5. Drink loads of water to remain hydrated.